Instruction Guide

 

Below, you will find the instruction guide in your selected language. Please use the drop-down menu above to switch languages if you wish to view the guide in another language.

Package contents for each wall solution:

  • Wall shelf
  • Spacer strip
  • Cover cap
  • Sufficient screws and plugs

Required tools:

  • Spirit level or laser level
  • Pencil with a sharp point
  • Drill or hammer drill (depending on wall type)
  • 8mm masonry drill bit or concrete drill bit (depending on wall type)
  • Hammer Phillips screwdriver or screwdriver machine

Hang your wall solution in 7 easy steps:

  1. Check if the wall is flat and ensure there are no pipes and cables within the wall at the desired drilling location. 
  2. Determine the height where you want to hang the shelf and then use a spirit level or laser level to mark a straight pencil line on the wall.
  3. Carefully place the spacer strip on the marked pencil line. You may need someone to help hold the spacer strip in place. Then trace the hole pattern of the spacer strip onto the wall by marking the holes with a sharp pencil.
  4. Remove the spacer strip and proceed to drill the holes for the plugs. Ensure the holes are drilled accurately and the drill does not "run off".
  5. Then insert the plugs into the drilled holes and gently tap them until the top of the plug is flush with the wall surface.
  6. Now the wall shelf can be installed. It's helpful to do this with two people. Ensure the spacer strip is positioned between the wall and the shelf. Insert the screws and tighten them using a screwdriver or screwdriver machine.
  7. Finally, place the cover cap over the screw section of the shelf. It will stick to this surface due to the attached magnetic tape.

Enjoy your wall solution!